AM SERVICE TRAINING Featuring the AM-50BAE, AM-100BAE, AM-150BAF 80047 www.hoshizakiamerica.com 5-20-
- 10 - CONTROL BOARD: A solid state board controls the AM operation. The control board is factory adjusted to produce consistent ice in all amb
- 11 - Preventative maintenance for the AM is simple. Follow these steps to allow the unit to operate efficiently. 1. Clean the condenser onc
- 12 - Cleaning tips: • A detailed cleaning label is located on the back of the icemaker door of the AM-50BAE or on the back of the bin baffle
- 13 - Disconnect the suction tube that connects the pump motor to the sump tank. The AM-50BAE has a locking tabs that can be released by compres
- 14 - AM-50BAE: Lift off the ice chute from the front frame pipe and then from the rear frame pipe clean and sanitize the ice chute The AM-100 &a
- 15 - Refit the caps on the cleaning outlets to seal them off. AM-50: Slide in the spray assembly along the rail
- 16 - AM-50: Position and lock the ice chute on to the front and rear frame pipes by pushing the chute down until it clicks AM-10
- 17 - AM-50BAE: Refit the suction tube on to the water tank inlet by pushing the joint to lock it securely in the arrow directions.
- 18 - AM-50BAE
- 19 -
- 2 - 20mm All AM models have similar sequence of operation. This manual is designed as a generic AM Training manual.
- 20 -
- 21 - AM-50BAE Electrical Specifications: The unit is 115 volt/ 60 hz. /1ph. The AM-Series should
- 22 - Electrical Specifications: The unit is 115 volt/ 60 hz. /1ph. The AM-Series should be connected to a separate 15Amp circuit. AM
- 23 - Electrical Specifications: The unit is 115 volt/ 60 hz./1ph. The AM-Series should be connected to a separate 15Amp circuit. AM-150
- 24 - AM-50BAE & AM-100BAE Low side process tube High side process tube Note: All Hoshizaki ice machines are critically charged. Since th
- 25 - WATER AND REFRIGERATION CIRCUIT AM-150BAF Note: All Hoshizaki ice machines are critically ch
- 26 - Freeze time = Thermistor reads 26.6ºF (-3ºC) then completes 8 minute Freeze cycle completion timer. Harvest time = Thermistor reads 4
- 27 - SERVICE DIAGNOSIS
- 29 -
- 3 - WATER INLET CONNECTIONS A standard 120-volt power cord provides the electrical connection. The unit
- 30 - AM SERIES REVIEW QUIZ Choose the best answer for each question below. 1. The AM control board is located in the rear or the unit.
- 31 - (NOTES) Quiz answers: 1.False, 2. True, 3. Open, 4. R-404a, 5. True, 6. True, 7. True
- 4 - In the case of an AM-50 if a drain is not located in an area that will allow for the proper fall, there is an optional condensate pump av
- 5 - The horizontal evaporator and water distribution system are unique to the Hoshizaki AM and IM series. The A
- 6 - The AM series uses a combination thermistor and control board to control the sequence of operation. When the toggle switch is placed in th
- 7 - Throughout the freeze cycle, which normally last 14~33 minutes, depending on model and operating conditions, the unit will continue to
- 8 - The AM series uses a thermostatic bin control located on the right rear side of the ice storage compartment. This control will open when
- 9 - AM-50BAE: The control switch is marked “ICE- OFF-WASH” and is located on the lower right front of the unit. AM-100 & AM-15
Kommentare zu diesen Handbüchern