Hoshizaki C-100BAF Bedienungsanleitung PDF herunterladen (Seite 24)

D. Setup

1) Position the icemaker in the selected permanent location.

2) Level the icemaker from side-to-side and front-to-rear by adjusting the feet.

E. Electrical Connection

WARNING

• Electrical connection must meet national, state, and local electrical code

requirements. Failure to meet these code requirements could result in death,

electric shock, serious injury, re, or severe damage to equipment.

• This unit requires an independent power supply. See the nameplate for proper

voltage and breaker/fuse size. Failure to use a proper breaker or fuse can result

in a tripped breaker, blown fuse, damage to existing wiring, or component failure.

This could lead to heat generation or re.

• THIS UNIT MUST BE GROUNDED: This unit is equipped with a 3-prong

grounding plug to reduce the risk of potential shock hazards. It must be plugged

into a properly grounded, independent 3-prong wall outlet. If the outlet is a

2-prong outlet, it is your personal responsibility to have a qualied electrician

replace it with a properly grounded, independent 3-prong wall outlet. Do not

remove the ground prong from the power cord and do not use an adapter plug.

Failure to follow these instructions may result in death, electric shock, or re.

• Do not use an extension cord.

• To reduce the risk of electric shock, make sure the power switch is in the "OFF"

position before plugging in or unplugging the unit.

• To reduce the risk of electric shock, do not touch the power switch or plug with

damp hands.

• Do not use a unit with a damaged power cord. The power cord should not be

altered, jerked, bundled, weighed down, pinched, or tangled. Such actions could

result in electric shock or re. To unplug the unit, be sure to pull the plug, not the

cord, and do not jerk the cord.

• The GREEN ground wire in the factory-installed power cord is connected to

a screw on the gear motor base where the cord enters the unit. If it becomes

necessary to remove or replace the power cord, be sure to connect the power

cord's ground wire to this screw upon reattachment.

• Usually an electrical permit and services of a licensed electrician are required.

• The maximum allowable voltage variation is ±10 percent of the nameplate rating.

• For optional drain pump (HS-5061) installation, refer to the instructions included with

the pump.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 39 40

Keine Kommentare

Hoshizaki C-100BAF Bedienungsanleitung Seite 24