Hoshizaki KM-101BAH Bedienungsanleitung PDF herunterladen (Seite 14)

Tapped Hole

(Leg Mounting)

Base

Adjustable Leg

Fig. 3

5) When installing the unit with legs on the bottom, use the

four accessory legs adjustable from 6” (15.2 cm) to 7”

(17.8 cm). Screw the legs tightly into the tapped holes in

the base (see Fig. 3). Handle the icemaker carefully not to

damage the exterior.

E. Electrical Connection

WARNING

• Electrical connection must meet national, state, and local electrical code

requirements. Failure to meet these code requirements could result in death, electric

shock, serious injury, ﬁ re, or damage.

• The appliance requires an independent power supply of proper capacity. See the

nameplate for electrical speciﬁ cations. Failure to use an independent power supply of

proper capacity can result in a tripped breaker, blown fuse, damage to existing wiring,

or component failure. This could lead to heat generation or ﬁ re.

• THE APPLIANCE MUST BE GROUNDED: The appliance is equipped with a NEMA

5-15 three-prong grounding plug to reduce the risk of potential shock hazards. It must

be plugged into a properly grounded, independent 3-prong wall outlet. If the outlet

is a 2-prong outlet, it is your personal responsibility to have a qualiﬁ ed electrician

replace it with a properly grounded, independent 3-prong wall outlet. Do not remove

the ground prong from the power cord and do not use an adapter plug. Failure to

properly ground the appliance could result in death or serious injury.

• Do not use an extension cord.

• To reduce the risk of electric shock, do not touch the control switch or plug with damp

hands. Make sure the control switch is in the “OFF” position before plugging in or

unplugging the appliance.

• Do not use an appliance with a damaged power cord. The power cord should not

be altered, jerked, bundled, weighed down, pinched, or tangled. Such actions could

result in electric shock or ﬁ re. To unplug the appliance, be sure to pull the plug, not

the cord, and do not jerk the cord.

• The GREEN ground wire in the factory-installed power cord is connected to the

appliance. If it becomes necessary to remove or replace the power cord, be sure to

connect the power cord’s ground wire to this screw upon reattachment.

• Usually an electrical permit and services of a licensed electrician are required.

• The maximum allowable voltage variation is ±10 percent of the nameplate rating.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Keine Kommentare

Hoshizaki KM-101BAH Bedienungsanleitung Seite 14